Building Filled Regions with the Fill Tool

Create filled regions from the boundaries in the drawing, then inspect the resulting element construction.

The Fill Tool

The Fill tool chooses which enclosed regions are solid or hollow. It does not assign a stroke width or turn a skeleton into a stroked outline.

Press F to activate it. Hover over an enclosed region and inspect the highlight, then click to fill that region or Alt-click to make it hollow. Repeat for each region you want to change. Holding F temporarily accesses the tool; releasing it returns to the previous tool.

The tool chooses its mechanism according to the geometry. With simple, non-overlapping contours, it can reverse a contour's direction without creating a filter. With overlapping contours, it can create a live Fill filter, preserving the source contours and calculating the chosen regions from their arrangement.

For a straightforward counter, such as the inside of an O, use Reverse Contour when direction is the only issue. Reserve a Fill construction for regions formed by more complex overlaps, where selecting the desired areas is easier than specifying a sequence of Boolean operations.

Shift-click with the Fill tool reverses one contour's direction directly. This is useful when you already know which contour needs reversal and want to work on the canvas.

Fill across several elements

The Fill tool normally works within one element. For regions formed across separate elements, group those elements first. Use ordinary contour elements or element references; convert components with Element > Reference > Component to Reference before using this workflow.

To make a transparent letter inside a solid disc:

  1. Use Element > Reference > Add Reference… to add the disc and the letter as element references.
  2. Position and size them so that the letter fits within the disc.
  3. Select both with the Element tool and choose Element > Group.
  4. Make the group current and activate the Fill tool.
  5. Alt-click the letter's regions to hollow them, checking each highlighted area before clicking.

Check the letter's counters as well as its main strokes. The tool applies a choice to a region; it does not infer a complete inverted alphabet from one click.

Edit a Fill construction

You can continue changing the source contours while the filter is live. However, a fill choice depends on the regions formed by their arrangement. Moving contours apart and then back together can require you to choose the regions again. Recheck the result after a structural edit, especially when a previously enclosed region opens or splits.

Use Element > Expand Filters to turn a completed Fill construction into ordinary contours, or Element > Remove Filter to discard it. If no filter was created because the tool only reversed a contour, undo or reverse that contour again to restore its direction.

A Fill construction is a different way of specifying a Boolean result: Fusion starts with the operation and stacking order; Fill starts with the areas you want to keep or remove. For a design with several masters, check those areas in each master and between them. An overlap arrangement that changes during interpolation can change the regions available to the filter.