Erasing Contour Areas
Remove an area of artwork and inspect the remaining contour structure before continuing the drawing.
The Eraser and the Erasing Rectangle
Press 2 or select Eraser. Open its toolbox and choose the form of removal you need.
Remove points deletes nodes or handles under the circular cursor. Click one point or drag across several. Hold Shift to protect key nodes that FontLab identifies as important to the shape. Control-drag adjusts the erasing radius. Removing a point can change the curve even when the path remains connected.
Lasso eraser removes points inside a freehand enclosure. Draw around only the intended area and inspect the highlighted targets before finishing. Shift provides key-node protection here as well.
Simplify path works between two chosen nodes on the same contour, unlike the broader Simplify command in Structural Soundness. Click the first, then the second, to reduce the intermediate structure. Compare the resulting span with the original, especially on a closed contour where there are two possible routes between the endpoints.
In the basic Eraser state, Option/Alt-click can remove a segment or break around a node, leaving an open path. Use the explicit Knife Break operation if an opening, rather than point removal, is your main intention.
For a rectangular cutout, select Erasing rectangle in the Rectangle tool group. Drag across the region to subtract; hold Shift for a square or Option/Alt to draw from the center. This removes geometry and resolves the cut. It does not place a white rectangle over the drawing.
After erasing, switch to the Contour tool and inspect the remaining nodes, closure, and corners. Undo an overly broad cut before making further edits that would make the original geometry harder to recover.
Live fill alternatives are covered in Assembling Elements with Fusion.
Use the Cleaner Rectangle
Drag with Cleaner to erase a rectangular area. Hold Shift to constrain the rectangle to a square or Alt/Option to draw it from the center. Inspect the resulting open and closed contours before export. This is an area-removal operation rather than the Trowel tool’s simplification of a path.