Making Masters Compatible

Repair correspondence between source drawings before relying on their interpolation.

Save the editable source and identify the glyph and master pair that fail interpolation. Start with Previewing and Diagnosing Interpolation if you have not yet located the mismatch.

Making Masters Compatible

Save the source before applying repairs that can reorder or reconstruct contours. Start with one glyph so that you can inspect what changed.

Try automatic matching

The Variations panel’s Check masters geometry and Sort contours and start nodes options affect dynamic matching. The latter corrects contour order and start-node differences during interpolation, but cannot compensate for different on-curve node counts. To commit corrected ordering to the source, use Glyph > Match Masters, or Match Masters in Layers & Masters or the Matchmaker property bar. A normal click in Matchmaker respects the configured automatic-matching options. Shift-click requests the stronger set of corrections regardless of those current options.

Matching can sort elements and contours, relocate starting points, reconcile directions, and correct supported segment differences. It is more than a count comparison, but it cannot infer that an absent bowl or an extra decorative contour should be designed a particular way. Resolve genuine design-content differences yourself.

Inspect the masters after matching, including components and references. Do not assume that every source structure was retained unchanged just because the appearance stayed similar. Recheck the live instance and the intended reusable relationships.

Correct order, direction, and starts

If the wrong contours correspond, arrange them consistently in the Elements panel. If directions disagree, Alt-click a contour node in Matchmaker to reverse that contour. The Set PS contour direction control works on the current master; Shift-click extends that operation to the visible masters.

Shift-click a node in Matchmaker to make it the contour's start. Place starts at corresponding design landmarks. The Relocate startpoints control offers automatic placement; Shift extends it to the visible masters. Automatic bottom-left-oriented choices still need inspection when the masters' shapes differ substantially.

Reconcile a problem section

Use manual section matching only where the correspondence needs repair. It can add or remove nodes, so applying it indiscriminately to an already correct glyph can make matters worse. Before matching, review Allow to clean up segments: it permits removal as well as addition of nodes. Enable it only when that reconstruction is acceptable.

  1. Show the masters you intend to reconcile and identify the same continuous section in each.
  2. Drag a marquee around its beginning nodes across those masters. This establishes the blue beginning selection.
  3. Drag another marquee around its ending nodes to establish the orange ending selection. Extend a selection with Shift-drag where needed.
  4. Inspect both sets of boundaries, then press Enter to reconcile the intervening sections.
  5. Check the changed contours and repeat only for another unresolved section.

Inspect whether the reconstructed sections preserve the intended curves.

A repaired glyph should produce its live instance and pass the relevant structural checks. Finish by scrubbing the actual axes again. Check the drawing, spacing, and attachments at intermediate locations; a green status is a starting point for that design review, not its conclusion.