Breaking and Joining Contours

Open or reconnect contour paths and set their start points deliberately.

Use the Contour tool in the intended glyph layer. Select the node or endpoints for the operation and inspect whether the path is open or closed. For the underlying distinction, see Contours, Nodes, and Handles.

Breaking and Joining

Select a node and choose Contour > Break (Cmd+B on macOS, Ctrl+B on Windows). The node becomes two coincident endpoints. Breaking one point opens a closed contour; breaking several points can create several open paths.

Select two open endpoints and choose Contour > Join (Cmd+J or Ctrl+J). Coincident endpoints merge into one point. Separated endpoints are connected by a straight segment. Joining the two ends of the same path closes it; joining ends from different paths combines them.

The new connection can change the silhouette or introduce a corner. Inspect it at a useful zoom before continuing. The arrow-shaped endpoint markers identify an open path; recall the open/closed distinction in Contours, Nodes, and Handles. Ordinary filled-outline production requires closed contours, so check closure again after editing.

Breaking and joining serve different construction purposes. Breaking gives access to a section without necessarily moving its endpoints. Two endpoints can occupy the same coordinates and still belong to an open path: touching positions do not by themselves establish a closed connection. Joining makes the structural connection explicit. If the endpoints are separated, the added straight segment becomes part of the outline and may need later refinement.

Before joining, check that you selected the intended pair. In a crowded drawing, nearby endpoints can belong to different contours. Compare the connection with the intended silhouette, then inspect the other ends of the affected paths. A successful join of two paths does not imply that the combined path has no remaining open ends. Keep the distinction between the local operation and the state of the whole contour.

Setting the Startpoint

Select the node that should begin a closed contour's sequence, then choose Contour > Set Start Point. Enable View > Contours > Contour Direction if you need to see the start marker clearly.

With no point selected, Set Start Point chooses a suitable start for each contour in the current drawing layer, favoring corner nodes on line segments near the origin. Make a selection when you want one specific contour and point.

Changing the start point changes point order without moving the closed outline. That order can matter to interpolation and point-based font data, so preserve it deliberately when such relationships already exist. Open contours also have a first point, but their endpoints define the path's beginning and end. Matching masters is covered in Interpolation and Compatibility; hinting and point-based relationships are developed in Hinting and the Pixel Grid and The TrueType Hinting Model.

Use a deliberate start point when contour order is part of another relationship. A closed outline is cyclic: it can have the same shape while its stored sequence begins at a different node. That means a visual comparison of filled glyphs alone may not reveal the change. Inspect the start marker and contour direction as well as the silhouette.

For a simple drawing without dependent point references, choosing a convenient start can make later inspection easier. For related masters or already instructed outlines, consider those dependencies before changing order. Work on a saved source and compare the affected designs afterward. Set Start Point is a structural choice, not a repair for a badly shaped curve or an inconsistent direction. Choose the operation that matches the problem rather than using it merely because the marker appears inconvenient.

Italic-angle setup is covered in Preparing for Italics; alignment zones are developed in Defining PostScript Alignment Zones.