Using Power Guides
Link outline nodes to a guide so that moving the guide reshapes the drawing. Use paired guides when you need to coordinate both boundaries of a measured region.
Power Guides
A power guide has nodes linked to it. Moving the guide then moves those nodes. Unlinked nodes between two power guides interpolate proportionally as those references move, allowing a coordinated change to a larger part of the drawing.
Use the Attach tool (U) to drag from a node to the intended guide. Enable Node Links in the contour view controls to inspect the link indication. Links act horizontally or vertically; a node can carry at most one link in each direction, even when the guide is angled.
Make a small trial movement with the Contour tool and check the whole outline. Linked nodes follow their guide, while intermediate and neighboring points can also respond. Undo if the reference controls a larger region than intended.
To remove a link, use Attach to drag the linked node toward empty canvas. Tools > Guides > Unlink Power Guides provides broader removal. A guide can remain a power guide while other nodes are still linked to it.
Preserve a stem while changing proportions
Place a vertical guide at each edge of a stem and link the nodes on each edge to its guide. To move the stem without changing its width, move both edge guides by the same horizontal distance. Moving only one edge changes the width. For example, moving guides from x = 100 and x = 180 to x = 120 and x = 200 shifts an 80-unit stem by 20 units while preserving its width. Paired horizontal guides provide the analogous control for a horizontal stroke.
To change the glyph’s overall proportions while retaining stem widths, coordinate its bounding guides with these edge pairs. Move each pair by equal amounts when its stem should retain its thickness; change the distance between pairs to change the intervening space. Horizontal guides can establish height references in the same construction. The result is controlled reshaping, not an assurance that any movement of one guide preserves every width. Inspect the unlinked points that interpolate between the references as well as the linked stem edges.
This setup lets you alter spaces between strokes while retaining chosen stroke dimensions. It does not automatically preserve every width simply because guides have been linked.
Nodes cannot be linked directly to the font dimension lines through this workflow. Instead, position an ordinary guide with an expression such as caps_height, then link nodes to that guide. With Live Metrics enabled, spacing expressions can also recalculate after the drawing changes, so inspect spacing as well as contours.
Guide-to-zone and guide-to-hint conversion is taught in Defining PostScript Alignment Zones. Copying guide properties across masters is developed in Managing Layer Content. Hints and alignment zones can also serve as power-guide references; font dimension lines cannot be linked directly through this workflow.